Clone Kit™ Assembly Instructions

The Clone Kit is now shipped assembled.

Assembly of the Clone Kit© is easy, requiring no tools. The two main parts,

the cloning chamber and the lighthood, fold into shape the way a foldable box does.

	Fold up the sides of the cloning chamber to form the basic shape. The textured surface is on the inside.
	Line up the corner holes and insert the long half of the friction fastener (from the outside). Push the flat down with your fingers. Do all four corners as pictured, leaving the top holes empty for now (these are the holes used to fasten the lighthood).
	Now affix the light hood to the clone chambers top holes. Using 6 (3 for each side) friction fasteners. Again,working from the inside, push the flat part of the fastener on.
	Slide the light into the lighthood. Position the light with the foam blocks, and run the wire out the corner.
	Fold the light chamber flaps down and secure with the plastic wing nut fasteners.